Welcome to the 3D-technologies

Items mounting

Items mounting
Description of ways of mounting of the made products from a wood, polyurethane and other materials.

Mounting - Groove in the wood

The picture showing the option of fastening to the screw with the help of a groove cut in an wood

Mounting (fastening) of products on a vertical surface by means of screws screwed into this surface and the milled groove in a wood or sheet material is the most often applied option of fastening for products of the small and average size. This option allows you to provide a hinged method of fixing the product with a tight fit to the surface on which the product is attached. For these purposes, in the body of material from which the product is made, with the help of a T-shaped cutter, one or more grooves of a special shape are cut, allowing the product to be securely held on standardized screws with a press washer mounted in the surface. The shape of the grooves is such that it does not allow the product to jump off the mounting screws in the normal position.


Mounting - Incut metal loop

The picture showing the option of mounting on a mortise metal loop

Another option for mounting (fixing) the product with screws or special anchors on a vertical surface is a incut metal mount. This is the most suitable mounting option for massive products, and products made of wood or other materials that must be attached to a wall or other surface with a tight fit. To do this, in the body of material from which the product is made, special shaped grooves are cut, into which one, two or more incut metal loops are mounted with screws.


Mounting - Outer loop

The picture showing the option of mounting on the hinged outer loop

Mounting (fastening) with a special metal outer loop - this is the most suitable mounting option for small products, and products made of wood or other materials for which there is no requirement for a tight fit to the mounting surface. In this case, one or more special mounting loops are mounted on the rear plane with screws.

In addition, mounting on the outer loop is an acceptable option for mounting thin products in which it is not possible to cut a groove in the wood or mount a incut mount.

This option is able to withstand sufficient holding loads (product weight), but does not provide the ability to fix the product with a tight fit to the mounting surface.


Additional information on mounting options

Typical mounting options we take into account in the proposed options.

But, if you need to make a product with some special atypical mount, the option of which is not specified in the selection options, for example, mounting on a hemp rope, chain, special stand or other, then you can easily do it by clicking the "Send request" button. In this case, the feedback form window will open. Specify in the letter the details of your order. We will send you an offer.

Dimensions are scaled to the required

The 3D models and drawings available in our collection are scaled up and down. Accordingly, products made on the basis of three-dimensional models can be increased or reduced to a reasonable size.

If the code table size is not specified the required size, then You can send a request to our address or call the Contacts phone numbers. We will consider your request and reply convenient way for you.


Check prices with our manager please!